Need help...,

[wfc31]

i have a 2" meter pillar for my Wira, can anybody tell me how to take out my OEM driver side plastic pillar cover in order to install the gauge pillar?
i don want to overlap it on the OEM plastic pillar because my gauge pillar is direct fit size as the OEM one.

 

[jinkl]

how to take out.. easy
put a screw driver .. and push it out thru the corners..
its actually juts clips la inside :D

 

[wfc31]

jinkl,
:o , it is just a clip like the door panel? no screw or any tightening stuff? how many clip it does, top / center / bottom ?
just push it out by screw driver?

 

[wfhan]

ya just clips, careful when u "korek" out the pillar panel
might break some clip's leg. better get some
spare one first b4 u DIY on this incase some of the leg
breaks..

 

[wfc31]

wfhan,
u mean 'korek' is push out the pillar?
'korek' from the top size rite?
i try to korek, but i seem like very tight ler, no problem ah?

 

[Shanashi]

korek from the top...then after the first clip from the top is out try korek the second clip but note dont pull it towards the passenger side instead try "pulling" it from the top after the second clip is out cuz of the dash unless you dont mind scratches....hope this helps....but no biggie just pull da frigging thing out only k :lol:

 

[wfc31]

thankz bro, will try again.