evo 3 problem.

[perry gazoo]

my evo 3 was workin so sweet until the timing belt burst. damage some valves. i replace the bent valves and bolt back up the head.all the mating marks are dead on but the car not running how it use to. i double check the timing over and over and it dead on .any helps for you guys?

 

[ed78]

Were there any other damages to the head? was the head skimmed well after fitting? it may cause leaks and lost of pressure........... piston damaged?

 

[jinkl]

thts the reason i wont replace valves or etc , bent ? throw the head away, cause there might be small small stuff tht we dont notice owith a naked eye

 

[perry gazoo]

No the block is fine. i did a compression test and its ok.

---------- Post added at 07:57 PM ---------- 6 hour anti-bump limit - Previous post was at 07:56 PM ----------

also i notice the belt need a little more tension. that could be the cause?

 

[huakenny]

No the block is fine. i did a compression test and its ok.

---------- Post added at 07:57 PM ---------- 6 hour anti-bump limit - Previous post was at 07:56 PM ----------

also i notice the belt need a little more tension. that could be the cause?

if compression test ok, check the balance shaft n timing marking....wat head gasket using?